Correct use of ozone sterilizer
Correct use of ozone sterilizer
In the process of producing super oxygen (ozone), the ozone sterilizer generates heat, which increases the temperature inside the machine. The higher temperature will accelerate the decomposition of super oxygen (ozone), promote the reduction of super oxygen (ozone) into oxygen, and reduce the amount of super oxygen (ozone). Therefore, in the process of generating super oxygen (ozone), the ozone sterilizer must be cooled to stabilize and increase the generation of super oxygen (ozone).
The cooling method of ozone sterilizer includes air cooling and water cooling. Industrial ozone sterilizers are mostly medium and large ozone sterilizers, which are commonly cooled by water cooling, and air cooling is mostly used in civil fields.
In the process of designing and using the ozone sterilizer, the relevant rules must be followed to obtain high-yield super oxygen (ozone) and ensure the normal operation of the ozone sterilizer.
Mainly include the following aspects-
1. The gas in the ozone sterilizer must not contain hydrocarbons, corrosive gases, and any other substances that can react in the oxygen/superoxide (ozone)/corona environment. These substances will damage the ozone sterilizer, and It may cause spontaneous combustion, explosion and other safety accidents.
2. When designing the water-cooled ozone sterilizer, prevent the possibility of a large amount of water entering the generator. If the float valve of the water-sealed air supply compressor or the condensate valve on the air dryer is blocked, everyone will enter the corona room of the ozone sterilizer, which will lead to corona concentration, high current density and local dielectric heating. Lead to premature failure of the dielectric.
3. Reasonably control the change of air supply pressure. The air pressure will affect the corona power induction and the applied voltage across the dielectric, and a wide range of pressure changes will cause the generator to operate unreliably. Exceeding the corona power range will cause the fuse or automatic breaker to be disconnected. If the peak value of the applied voltage is exceeded, it will cause premature failure of the dielectric.
4. Regardless of whether it is air-cooled or water-cooled, the internal and external temperature of the generator should be controlled within 60 degrees as much as possible. If the temperature exceeds 60 degrees, the output of super oxygen (ozone) will decrease, and the output will continue to decrease as the temperature increases.
