Car cigarette lighter note

Cigarette lighter is a conventional configuration on the car, but the use of the car cigarette lighter what precautions are we to understand it?.

Car cigarette lighter note

1, to avoid foreign body into the lighter hole

Need to always check the cigarette lighter is tucked into the foreign body, so as not to damage the car cigarette lighter, if the vehicle has lighter protection cover, to timely cover, some advanced vehicle trunk has lighter spare interfaces, should pay attention to whether the entry of foreign matter.

2, avoid the use of high power on the cigarette lighter

The cigarette lighter general maximum power is more than 120W, this value is likely to cause overload caused by burning cigarette lighter, cigarette lighter and other dangerous, so the equipment in use, be sure to look at the maximum power, try to use less than 120W.

3, reasonable plug cigarette lighter plug

Cigarette lighter with safety device alone, the correct way is to use the vertical inserting and pulling out, not shaking out, often shaking loose and easy to cause the cigarette lighter insurance circuit, very easy to be burnt out insurance and external equipment.

4, after the parking out of the equipment in a timely manner

When the vehicle flameout, should unplug the cigarette lighter on the external devices, or when the vehicle starts, easy to burn equipment in large current impact, especially MP3 and U disk appear easily, so to unplug the car after parking, then insert the use start.

5, the use of cigarette lighters as long as possible to launch vehicles

If a long time to use the cigarette lighter, or larger power equipment, need to start the car engine to enhance power, so it will not consume car battery power, because cigarette lighter car are DC generator taken from the car, as long as the car engine running in drive generators for power generation, car electricity comes from this, if you do not start the vehicle, the battery power consumption directly, easy to cause the battery voltage is too low, it is difficult to start the car, the equipment can not work properly.

6, often clean electric cigarette butt wire

Due to cigarette smoke need to touch the hot wire, we should pay attention not to force too much hot wire, if the tobacco and other objects fall into the hot wire to be cleaned in time, so as to extend the service life of cigarette lighter.

Introduction to car cigarette lighter

The cigarette lighter, as the name implies, one thing is used for lighting, cigarette lighter power supply voltage is 12 volts, is consistent with the battery voltage of the vehicle, usually lighter with a single power line is connected, and the other line is not mixed, therefore, there is a separate insurance, part of the cigarette lighter iron shell is the cathode of the power supply, the electric wire in the middle is the power of the cathode, when inserted into the cigarette lighter and pressed down after locking, positive contact, lighter and lighter socket of the electric heating when the temperature reached after the electric heating plate, affected by temperature, Kahuang variant, release seatand cigarette is pop, can light a cigarette, after inserted into the socket (no longer press), will naturally reduce the temperature of electric heating plate.

Method for using automobile cigarette lighter

1, open the power supply of the car (some cars must be energized before you can use a cigarette lighter power).

2, the cigarette lighter into the power socket.

3, put the cigarette lighter into the power socket, and down the lock (solid).

4, the lighter began to heat, when the cigarette lighter heating wire temperature, will automatically pop up, or wait for 5-8 seconds can be red hot wire, do not need to wait until it pops up, you can also manually pull out.

5, after the cigarette lighter, put the cigarette lighter back to the power socket position.